Monday, October 14, 2024
HomeTechnologyInstructional Guide to Fix Rockspace Extender Red Light Issue

Instructional Guide to Fix Rockspace Extender Red Light Issue

Each LED light on a Rockspace wireless range extender has a meaning. However, in case the LED is blinking red instead of green, then you are in grave danger. We can say this because the blinking of the red light can degrade the performance of your networking device completely. To prevent that from happening any further, we have written this post. Here, we have talked about some troubleshooting hacks with the help of which, you will be able to resolve the Rockspace WiFi extender red light issue in the blink of an eye. Are you ready? Get, set, go.

[Fixed] Rockspace Extender Red Light Issue

  1. Restart the Rockspace Extender

The very first thing that you can do to troubleshoot the Rockspace extender red light issue is to try to restart your wireless range extender. Restart, reboot, and power cycle, all these terms mean the same thing.

In order to give your device a brand new start, you need to first disconnect it from its existing wall outlet, hold on for some time, and then, connect it back to its wall outlet. Now, try to access the Rockspace setup wizard and check if the Rockspace extender red light issue climbed off of your back. No? Well then, following the 2nd troubleshooting hack is highly advised.

  1. Check the Ethernet Connection

Have a look at the connection between the Rockspace wireless range extender and the existing device, i.e. router. Is the not stable? Well, that might be because you have connected both devices with a damaged Ethernet cable.

To troubleshoot the Rockspace extender red light issue, you have got to change the Ethernet cable. Once that is done, it is recommended ensure that the connection is finger-tight. This can be assured by making sure that the Ethernet cable is tightly connected to the ports of both your devices.

  1. Reduce Signal Interference

Are you still a sad victim of the Rockspace extender red light issue? Well, that is because the signals of the wireless range extender are getting blocked. And do you know why that might be happening?

Well, because your device is kept near things like mirrors, fish tanks, microwave ovens, cordless phones, washing machines, baby monitors treadmills, televisions, refrigerators, and Bluetooth speakers. These things emit electromagnetic waves, hence stopping the signals emitted by your extender from expanding.

To take care of this, you need to change the location of your wireless range extender. Once that is done, check again if the Rockspace extender red light issue has bid farewell to you. Still, got no luck? Continue reading this article.

  1. Perform Rockspace Firmware Update

This is another hack that we recommend to users whenever they get stuck with the Rockspace extender red light issue. This hack requires you to update the firmware of your wireless range extender.

There is only one method through which performing Rockspace extender firmware update is possible. It is known as the manual method. If you want to know how to update the firmware of your wireless range extender in detail, take our advice, and refer to the guidelines given in the user manual of your range extender. Starting from how to setup Rockspace WiFi extender to how to reset it, you will find every little thing in there related to your device.

  1. Pull the Networking Devices Closer

Last, but not least, too much distance between the networking devices can also be a cause of the Rockspace extender red light issue. Therefore, it is recommended that you reduce the between them and see the magic unfold right in front of you.

For your information, too less distance between the extender and router can also become cause technical issues. Thus, see to it that there is not too less distance between them either.

Are you done following all the troubleshooting hacks? Good. Now, try to access the Rockspace WiFi extender setup page and see if the Rockspace extender red light issue has bid adieu finally.

The Bottom Line

With the hope of helping you out, we are wrapping up our guide to fix Rockspace extender red light issue. Surely your fellow readers would be excited to know about the hack that helped you out the most. Why don’t you spare some time from your busy schedule and share the same with them?

What is that? Do you not know how to do that? Well, it’s simple. You have got to type whatever you have to say in the comment section and press the Enter key. The one that is located on the keyboard of your system.

RELATED ARTICLES

Most Popular

Recent Comments